Wiring a Twin motor Twin Esc Setup

1. Take the motor wires from your speed controller  Normally they will be Yellow & Blue ,Yellow being the positive out of the speed controller  to a Electrical connector block .

2. Next  you will need to make the connections from the connector block  or bullet connectors too the motors Now on a lot of motors you will find a dot just next to or above one of the terminals now this is normally the positive connection mark so take the yellow wire to this Terminal on one motor and the Blue wire to that mark on the other motor .

3. Next plug the receiver leads from the speed controller into a y-lead then plug that into channel 2 on your receiver .
Now if both of your speed controllers have BEC you will need to make sure that  one of the speed controllers has the BEC system  disabled  as one of  these is not needed .

             Now this can be done in a number of way depending on the speed controller used .Most commonly removing the centre red wire of the receiver lead .
 Although you can still use a  separate receiver power supply as long as both Bec systems are turned off  if so you will need a separate supply of about 4.8 to 6 volt to power the receiver .

4. Next Plug your servo into channel 1.
 

5. Now  you will need to take  your two speed controller power connectors and taking the two red leads and joining them together and the two black leads and joining those together too  and connect  with a 7.2 connector block  or what ever your battery connector has .Make sure that if there is a switch on your speed controller it is set to on  and run though any setup that the speed controller needs .

            Now turn on you Transmitter first  and make sure your stick is in neutral on the transmitter .

 

 Text Box: Motor Positive mark Now this can be White or Red Text Box:  Battery Pack  Text Box: Electronic Speed controller           Bec type. { Please Note if not Bec  you will need to use a separate supply for the Receiver } NOTE One of the ESC must not have the BEC Enabled If no switch then remove the RED wire from the lead to the receiver Text Box:  Motors   Text Box: Connector Block Or Bullet Connectors Text Box: Batt Text Box: Ch 1 Text Box: Ch 2 Text Box: Receiver Text Box: Servo Plugs into Channel 1 Text Box:           = Negative             = Positive Text Box: Motor End View Text Box: Motor Terminal Text Box: On a twin motor set ups the wires need to be reversed on the terminals I.E where the yellow goes to the terminal with the positive mark on  one side it goes to the other side on the opposite motor so as to give contra rotating motors . Text Box: Y Lead Plug the two speed controller receiver leads into the y-lead then the y-lead into channel 2 on a two channel system or channel 3 on a multi channel  system Text Box: E.S.C Text Box: E.S.C Text Box: Take the Power supply to a connector block from there you can split the power to each of your Speed controllers . Please make sure you wire these up correctly Text Box: 7.2 Connector block